Table of Contents
Advertisement
4 Replacement Procedures
Installing the USB Board, Finger Print Board and Print Board
Install the USB board, finger print board and print board according to the following procedures and
Figure 4-31.
Note: Be careful of the kill switch button for the USB board. It can be damage when
installing the USB board. Make sure it is in the correct position.
1. Seat the print board in the correct position and connect the print SUMI-card to CN5000
on the print board.
2. Secure the print board with one M2.5x3 flat-round-head screw.
3. Connect the finger print SUMI-card to CN6052 on the USB board.
4. Seat the finger print board in the correct position and connect the finger print SUMI-card to
CN23 on the print board.
5. Connect the USB SUMI-card to CN3000 on the USB board.
6. Seat the USB board in the correct position and connect the USB SUMI-card to CN26 on
the system board.
7. Be sure the kill switch button is operational before proceeding.
4-50
4.12 USB Board, Finger Print Board and Print Board
Satellite A100/A105 / TECRA A7
Maintenance Manual
- Quick Links:
- Rtc Battery
Hide quick links:
Advertisement
Chapters
Table of Contents
