Sony SRW-5000 Maintenance Manual page 361

Hide thumbs Also See for SRW-5000:

Table of Contents

3. Adjust the AT Head Azimuth

(1) Play back the 12 kHz, 0 VU signal portion

(15:00 to 30:00) on the HR2-1A in the PLAY

(2) Turn the azimuth adjustment screw so that

the output waveform level becomes maxi-

(3) Lightly strike the portions A and B shown in

the figure with the tip of a screwdriver. Then

check that the output waveform level is

After the Adjustment

4. Adjust the AT Head Head-to-tape

Refer to Section 6-9.

5. Adjust the AT Head Position

Refer to Section 6-10.

6. Check the AT Head Height

Refer to Section 6-7.

7. Apply the Locking Compound

Refer to Section 6-1-9.

SRW-5000/5500

. Alignment tape : HR2-1A (15:00 to 30:00)

Height adjustment

Azimuth adjustment screw

AT Head Azimuth Adjustment