Table of Contents
Advertisement
Preparing the Receiver
Turning on the receiver
?/1
Press ?/1 to turn on the receiver.
You can also turn on the receiver using
on the remote control. When you turn off
the receiver, press
?
"STANDBY" flashes on the display panel.
Do not disconnect the AC power cord
(mains lead) while "STANDBY" is
flashing. This may cause a malfunction.
Setting up the receiver
using the Easy Setup
You can set the basic settings of the
receiver easily by operating the receiver in
accordance with the instructions on the TV
screen.
Switch the input of the TV to the input to
which the receiver is connected.
When you turn on the receiver for the first
time or after the receiver is initialized, the
Easy Setup screen appears on the TV
screen. Proceed to set up the receiver in
accordance with the instructions on the
Easy Setup screen.
You can set up the following functions
using the Easy Setup.
– Language
– Speaker Settings
30
GB
/1 again.
To set the surround back
speakers
You can switch the usage of the speaker(s)
connected to the SURROUND BACK/
BI-AMP/ FRONT HIGH/FRONT B
terminals in accordance with the intended
use. For details, see "SB Assign (Surround
back speaker assign)" (page 60).
Note
This setting is only available if the "Speaker
Pattern" is set to a setting without surround back
and front high speakers.
To set the front speaker
You can select the front speakers you want
to drive.
Be sure to use the buttons on the receiver to
/1
?
perform this operation.
SPEAKERS
Press SPEAKERS repeatedly to select
the front speaker system you want to
drive.
You can confirm the selected speakers
terminals by checking the indicator on the
display panel.
Indicators Selected speakers
SP A
SP B*
The speaker connected to the
SPEAKERS FRONT A
terminals.
The speaker connected to the
SPEAKERS SURROUND
BACK/BI-AMP/FRONT
HIGH/FRONT B terminals.
Hide quick links:
Advertisement
Table of Contents
