Table of Contents
Advertisement
(2) Heating test operation function
This function is provided to change collectively the mode of all the indoor units connected to the same system
for the heating test operation mode, by using switches on the interface board of the header unit.
<Operation procedure>
[1]
Set SW01/SW02/SW03 on the interface P.C. board of the header unit
to [2/6/1].
([H ] is displayed on 7-segment display [A].)
[2]
Press SW04 on the same board for 2 seconds or more.
[3]
[Test run] is displayed on the remote controller of
the indoor unit to be operated. Check that [ – H]
is displayed on 7-segment display [B] on the
interface P.C. board of the header unit.
[4]
Return SW01/SW02/SW03 on the interface P.C. board of the header
unit to [1/1/1],
or press the push-switch SW05 for 2 seconds or more.
Interface P.C. board
NOTE) The test operation returns to the normal operation after 60 minutes.
Power ON
Push switch
7-segment
display [A]
- 150 -
Be sure to turn on power at the indoor side
before power-ON of outdoor unit.
A
B
[
]
[
]
–
[H.
]
[
H]
SW04
SW05
SW01
SW02
Rotary switches
Start
Operation check
Stop/End
SW06
7-segment
display [B]
SW03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Toshiba MMY-MUP0801HT8JP
-
![Air Conditioner Toshiba MMY-MUP0801T8P Owner's Manual]()
-
![Air Conditioner Toshiba MMY-MAP0501HT8-E Owner's Manual]()
-
![Air Conditioner Toshiba Super Modular Unit MMU-AP0091H Installation Manual]()
-
![Air Conditioner Toshiba MMY-MAP0804HT8JP Service Manual]()
Related Content for Toshiba MMY-MUP0801HT8JP
-
