To change an indoor unit address using a wired remote controller.
<RBC-ASCU11*>
The method to change the address of an individual indoor unit (the indoor unit is paired with a
wired remote controller one-to-one), or an indoor unit in a group.
(The method is available when the addresses have already been set automatically.)
(Execute it while the units are stopped.)
1
Push and hold menu button and [
more.
(If 2 or more indoor units are controlled in a group, the first indicated UNIT No. is that of the head unit.)
2
Each time [
] [
change cyclically.
Select the indoor unit to change settings for.
(The fan and louvers of the selected indoor unit are activated.)
(The fan of the selected indoor unit is turned on.)
3
Push the Timer off button.
4
Push the menu button to make Code No. flash. Change Code No. to 13 with [
setting button.
5
Push the menu button to make Set data [****] flash.
Push the [
] [
section to that you want.
6
Push the Timer off button.
(When the display changes from [– –] to Set data [****] flashing, the setup is completed.)
7
When all the settings have been completed, push ON/OFF button to determine the settings.
"
SETTING
" flashes and then the display content disappears and the air conditioner enters the normal stop
mode. (The remote controller is unavailable while "
8
To change settings of another indoor unit, repeat from Procedure 1.
3, 6
4, 5
] setting button simultaneously for 10 seconds or
] setting button is pushed, indoor unit numbers in the group control
] buttons repeatedly to change the value indicated in the SET DATA
2, 4, 5
7
" is flashing.)
SETTING
- 130 -
] [
]