Table of Contents
Advertisement
Installing the Display Assembly
To install the T1900/T1900C's display assembly, follow the steps below and refer to Figures
4-15 through 4-17.
1.
Place the display assembly on the computer aligning the brackets with the screw
holes on the middle-frame assembly. Be sure to route the clear plastic insulator
between the display assembly and the bottom chassis (Figure 4-17).
2.
Replace the two M2.5x8 silver screws on the display hinges to secure the display
assembly.
CAUTION: If you replace a cable with a new one, be sure to bend and
route it as indicated in Figures 4-15 through 4-17 so that it fits snugly and
will not be pinched by the top cover or other components.
3.
Connect the display sensor switch cable to PJ11 on the system board (Figure 4-
17) .
4.
Connect the two display cables to PJ7 and PJ8 on the system board (Figure 4-17).
5.
Secure the M2.5x6 silver screw on the back of the computer (Figure 4-17).
6.
Set the system board cover in place and secure the display ground wire with an
M2.5x8 silver screw (Figure 4-16).
7.
Secure the system board cover with three M2.5x8 silver screws and two
M2.5x10 screws (Figure 4-16).
8.
Place the clear plastic insulator over the display cables and press it so that it
adheres to the system board cover (Figure 4-16).
9.
Set the display unit at a 90° angle to the base and insert the two hinge covers under
the left and right hinges (Figure 4-15).
10.
Install the display mask, keyboard base plate, keyboard, top cover, optional
PCMCIA card, optional memory card, and battery pack as described in Sections
4.8 through 4.2.
4-22
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
