Lan Troubleshooting - Toshiba PORTEGE S100 Maintenance Manual
Personal computer
Hide thumbs
Also See for PORTEGE S100:
- User manual (259 pages) ,
- User manual (216 pages) ,
- Maintenance manual (402 pages)
Table of Contents
Advertisement
2 Troubleshooting Procedures
2.12 LAN Troubleshooting
This section describes how to determine if the computer's LAN is functioning properly.
Perform the steps below starting with Procedure 1 and continue with the other procedures as
required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Replacement Check
Procedure 1
Diagnostic Test Program Execution Check
Execute the LAN test program available as part of the LAN/Modem/Bluetooth/IEEE1394
test program. Refer to Chapter 3, Tests and Diagnostics for more information on how to
perform the test program.
If any error is detected by the test, go to Procedure 2.
Procedure 2
Connector Check and Replacement Check
The RJ45 jack with LAN cable is connected to the system board. If the LAN malfunctions,
there may be a bad connection between the LAN jack and the system Board. Or the LAN
jack, system board or their connectors might be damaged.
Disassemble the computer following the steps described in Chapter 4, Replacement
Procedures and perform the following check:
Check 1
Make sure the LAN jack is firmly connected to J4100 on the system board.
If the connector is disconnected, connect it firmly and repeat Procedure 1. If the
LAN port is still not functioning properly, perform Check 2.
Check 2
The LAN jack may be defective or damaged. Replace it with a new one. If the
LAN port is still not functioning properly, perform Check 3.
Check 3
The system board may be defective or damaged. Replace it with a new one
following the steps in Chapter 4, Replacement Procedures.
2-44
2.12 LAN Troubleshooting
PORTEGE S100 Maintenance Manual (960-508)
Advertisement
Chapters
Table of Contents
Troubleshooting
