Table of Contents
Advertisement
Enabling TSETUP access in user password mode
There are two ways to display the menu letting you provide access to
TSETUP and other restrictions imposed by the supervisor password.
When you register a supervisor password and when you enter the
command SVPW/U at the DOS prompt.
To prevent a user from using this switch to access TSETUP, the supervisor
must copy the SVPW.EXE file to a diskette and delete it from the hard
disk.
1. a.) When you register a supervisor password the following message
appears.
To change the setting, press Y and go to step 2.
b.) Type SVPW/U at the DOS prompt and press Enter.
If the supervisor password is not registered, entering SVPW /U will
display the following message:
If the supervisor password is registered, one of the following sets of
messages will be displayed:
If TSETUP access is disabled (and other restrictions in effect):
If TSETUP access is enabled (and other restrictions disabled):
If you select N, you will return to the DOS prompt.
Select Y to change the setting.
You will be prompted to enter the current supervisor password:
Type in the password and press Enter.
User's Manual
USER PASSWORD MODE = Unable to run SETUP
Do you want to change the setting <Y/N>?
Unable to change user password mode because
supervisor password is not registered.
USER PASSWORD MODE = Unable to run SETUP
Do you want to change the setting <Y/N>?
USER PASSWORD MODE = Able to run SETUP
Do you want to change the setting <Y/N>?
USER PASSWORD MODE = Unable to show
Processor Serial Number item
Do you want to change the setting <Y/N>?
Supervisor Password--->
TSETUP and Passwords 7-21
Hide quick links:
Advertisement
Table of Contents
