Hard Disk Drive Pack; Removing The Hdd Pack - Toshiba Tecra M2 User Manual
Portable personal computer
Hide thumbs
Also See for Tecra M2:
- User manual (273 pages) ,
- Specifications (9 pages) ,
- Brochure & specs (28 pages)
Table of Contents
Advertisement
Optional Devices
6. Reinstall the cover of the memory module slot. Fasten the screw you
loosened in Step 4.
7. Reinstall the battery pack.
After installing a memory module, turn the power of the computer on to see
a total memory size. The system will calculate the total memory size.
Hard disk drive pack
An extra HDD expands the flexibility of your system and lets you carry your
data without carrying the computer.
Use a point size 0 Phillips screwdriver.
Removing the HDD pack
To remove the HDD pack, follow the steps below and refer to figures 8-15
and 8-16.
1. Set the computer to boot mode and turn off the power.
2. Disconnect the AC adaptor and all external cables connected to the
computer.
3. Remove the main battery and optional secondary battery when it is
used.
4. Turn the computer upside down and remove one screw securing the
HDD cover.
5. A small row of ridges mark latches securing the cover. Press on these
ridges until you hear a click.
6. Press on the arrows and lift the cover up and out to remove it.
7. Raise the HDD's plastic tab, pinch it and slide the HDD pack to
disconnect from the connector.
Be sure to slide the HDD pack first and confirm that the HDD pack has
disconnected.
8-12
Figure 8-15 Removing the HDD pack cover
User's Manual
Advertisement
Table of Contents
