Table of Contents
Advertisement
_ipe
•
Depending on your TV and other equipment you wish to
connect, there are various ways you could connect the
DVD/VCR
Receiver. Use connections
described on pages
11-14.
•
Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the best
connections.
Z_Oaution
•
Make sure the DVD/VCR Receiver is connected directly to
the TV. Tune the TV to the correct video input channel.
•
Do not connect the DVD/VCR
Receiveds DVD/VCR AUDIO
OUT jack to the phono in jack (record deck) of your audio
system.
•
Do not connect your DVDNCR
Receiver via your VCR. The
DVD image could be distorted by the copy protection sys-
tem.
Connecting
Antenna/Cable
TV to
DVD/VCR
Receiver
Disconnect the antenna leads from the rear of the
TV.
tdentify the type of cable from your antenna, tf it is
a round cable as illustrated, it is a 75 ohm coaxial
antenna cable. This cable will connect directly to
the jack marked ANT.IN on your DVD/VCR
Receiver.
_ip
If your antenna lead wire is a flat type antenna cable,
connect it to an Antenna Adaptor (300-ohm to 75-ohm)
(not supplied) and slip the Adaptor onto the ANT.IN
jack. The Adaptor does not screw on to the DVDNCR
Receiver, it just slips over the jack.
Without
Cable
Box
If your cable wire is connected to your TV without a converter
or descrambIer
box, unscrew the wire from your TV and attach
it to the ANT.IN jack on the DVD/VCR Receiver. Use the sup-
plied round coaxial cable to connect between the DVD/VCR
Receiver's RROUT jack and the 75 ohm antenna input jack on
the TV. With this connection, you can receive alI midband,
super band, and hyperband channels.
With
Cable
Box
If a converter is required in your cable system, follow the
instruction below:
The cable hookup permits both TV and DVD/VCR Receiver
operation.
To view or record a CATV channel
1 Tune the TV to the DVDNCR
Receiver output channel (OH
3 or 4).
2 Set the DVDNCR
Receiver channel selector to the output
channel of the Cable Converter box using CH/TRK (A/T) or
number (0-9) of your DVD/VCR
Receiver. (Example: OH3)
3 Select the channel to view at the Cable Converter Box.
Dotes
• With this connection, you CANNOT record one program
while viewing another.
• If you are using a cable box to tune channels, it is not nec-
essary to do Auto Channel Programming,
(Auto Channel
Search) as indicated on page 18.
Cable TV
Wall Jack
Antenna
Antenna
Wa,, oc
Flat Wire
:;
I_t
(300 ohm)
J
300/75 ohm
Adaptor
_
OR
OR
(Not supplied)
.....
u_ _
OUT
_ __
®®®=
......
Rear of DVD/VCR Receiver
X
.... ®®®o
Rear of DVD/VCR Receiver
Advertisement
Table of Contents
Troubleshooting
