Table of Contents
Advertisement
Connections
Antenna connections
If you are using an antenna system, follow these instructions. If you are a Cable TV subscriber, skip ahead to page 16 for
the proper connections.
Antenna to DVD/VCR connection
The DVD/VCR must be connected "between" the antenna and the TV. First, disconnect the antenna from the TV and
connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an antenna
system to a DVD/VCR. Find the type of antenna system you are using and follow the connection diagram.
1
2
3
Note:
If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm inputs and
one 75 ohm output.
Notes:
•
A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the antenna to
the DVD/VCR properly.
•
For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an outdoor type
antenna is required.
•
If you are not sure about the connection, please refer to qualified service personnel.
14
Downloaded From Disc-Player.com Toshiba Manuals
Combination VHF/UHF Antenna with 75 ohm Coaxial Cable
75 ohm Coaxial Cable
Combination VHF/UHF Antenna with 300 ohm Twin Lead (Flat) Wire
Matching Transformer 300 ohm Input 75
300 ohm Twin Lead (Flat) Wire
Separate VHF and UHF Antennas
Combiner 75/300 ohm Inputs 75 ohm output
UHF
VHF
300 ohm Twin Lead (Flat) Wire
75 ohm Coaxial Cable
ohm output (not supplied)
(not supplied)
(not supplied)
(not supplied)
DVD/VCR
IN
(ANT)
OUT
(TV)
DVD/VCR
IN
(ANT)
OUT
(TV)
DVD/VCR
IN
(ANT)
OUT
(TV)
Advertisement
Table of Contents
