Table of Contents
Advertisement
Changing the indoor unit address using a remote controller
To change an indoor unit address using a wired remote controller.
<RBC-AMT*>
The method to change the address of an individual indoor unit (the indoor unit is paired
with a wired remote controller one-to-one), or an indoor unit in a group.
(The method is available when the addresses have already been set)
(Execute it while the units are stopped.)
1
Push and hold the
(If 2 or more indoor units are controlled in a group, the first indicated UNIT No. is that of the head unit.)
2
UNIT LOUVER
Push the
button (left side of the button) repeatedly to select an indoor unit number to
change if 2 or more units are controlled in a group. (The fan and louvers of the selected
indoor unit are activated.)
(The fan of the selected indoor unit is turned on.)
3
Push the TEMP.
4
Push the TIME
section to that you want.
5
Push the
button.
6
UNIT LOUVER
Push the
button (left side of the button) repeatedly to select another indoor UNIT No.
to change.
4
6
Repeat steps
to
7
UNIT LOUVER
Push the
button (left side of the button) to check the changed addresses.
8
If the addresses have been changed correctly, push the
SET
DATA
SETTING
TEMP.
3
TIMER SET
5
TIME
FILTER
RESET TEST
SET CL
8
Finish
1
,
, and
buttons at the same time for more than 4 seconds.
/
buttons repeatedly to select
/
buttons repeatedly to change the value indicated in the SET DATA
to change the indoor unit addresses so as to make each of them unique.
CODE No.
UNIT No.
R.C.
No.
ON / OFF
4
2, 6, 7
13 13 13 13 13
for CODE No..
button to finish the procedure.
- 120 -
Advertisement
Table of Contents
Troubleshooting
