Table of Contents
Advertisement
11
2. Preparation: Attaching the Handle and Viewfinder
7
Attach the viewfinder loupe by sliding it
into the groove on the top of the LCD
monitor as shown in the diagram.
8
Push the viewfinder loupe in the direction
of the arrow to close it.
Removing the viewfinder loupe
Press the viewfinder loupe latch, raise the
loupe to open it , push and hold the
viewfinder loupe attachment lock tab in
the direction of the arrow , and slide the
viewfinder loupe in the opposite direction
from when it was attached to remove it .
Loupe
lock tab
Latch
Removing the viewfinder
1
Remove the cable from the cable holders,
press in both sides of the connector plug,
and disconnect the cable.
2
Loosen the viewfinder locking knob, and
use the reverse procedure of attaching
the viewfinder to remove it.
Attaching the Viewfinder (when
not using the viewfinder loupe)
1
With the handle attached to the unit, turn
the arm locking knob counterclockwise to
loosen the arm, and turn the arm 180°
toward the front.
2
Turn the locking knob clockwise to secure
it in position.
Locking
knob
Arm
Hex
socket
bolt
[Note]
If the arm attachment rod rotates relative to the
handle, tighten the hex socket head bolt (3 mm)
on the underside of the handle using a hex wrench
(tightening torque: 1.6 N·m).
3
Attach the viewfinder mount adaptor to
the side of the LCD monitor and turn the
locking knob clockwise to secure it in
position.
Viewfinder mount
adaptor
Locking knob
4
Press and hold down the pin on the arm
using your finger, attach the viewfinder
mount adaptor to the arm, and turn the
locking knob clockwise to secure it in
position.
Locking
Pin
knob
Viewfinder mount
adaptor
[Note]
If the arm becomes too loose when loosening the
attachment locking knob, adjust the lock screw
using a hex wrench (2.5 mm).
Advertisement
Table of Contents
