Table of Contents
Advertisement
74
4. Network: Connecting to Other Devices via LAN
• IP Address
Enter the IP address of the unit.
This setting is available only when
DHCP is set to Off.
• Subnet Mask
Enter the subnet mask of the unit.
This setting is available only when
DHCP is set to Off.
• Gateway
Enter the gateway for the access point.
This setting is available only when
DHCP is set to Off.
• DNS Auto
Sets whether to acquire DNS
automatically.
When set to On, the DNS server address
is automatically acquired. This setting is
available only when DHCP is set to On.
• Primary DNS Server
Enter the primary DNS server for the
access point.
This setting is available only when DNS
Auto is set to Off.
• Secondary DNS Server
Enter the secondary DNS server for the
access point.
This setting is available only when DNS
Auto is set to Off.
6
When finished, select Connect to connect
to the access point.
7
Connect the device to the access point.
For details about connecting, refer to the
operating instructions of the device.
8
Launch the Monitor & Control application
on a device and select the unit.
[Tip]
You can check the information required for
connecting to the unit using Network Setup >Show
Authentication (page 61) in the Network menu
of the full menu.
Connecting manually by entering access
point information
1
Perform steps 1 to 3 in "Connecting to an
access point using WPS" (page 73).
2
Select ST Mode Settings >Manual Register
(page 62) >Execute in the Network
menu of the full menu.
Momentarily, the network (access point)
details screen appears.
3
Configure the following connection
settings.
• SSID
Enter the SSID for the connection access
point.
• Security
Select the encryption method.
• Password
Enter the password for the connection
access point.
• DHCP
Set the DHCP setting.
When you set to On, the IP address is
assigned to the unit automatically.
To assign the IP address to the unit
manually, set to Off.
• IP Address
Enter the IP address of the unit.
This setting is available only when
DHCP is set to Off.
• Subnet Mask
Enter the subnet mask of the unit.
This setting is available only when
DHCP is set to Off.
• Gateway
Enter the address of the gateway.
This setting is available only when
DHCP is set to Off.
• DNS Auto
Sets whether to acquire DNS
automatically.
When set to On, the DNS server address
is automatically acquired. This setting is
available only when DHCP is set to On.
• Primary DNS Server
Enter the address of the primary DNS
server.
This setting is available only when DNS
Auto is set to Off.
• Secondary DNS Server
Enter the address of the secondary DNS
server.
This setting is available only when DNS
Auto is set to Off.
4
When finished, select Connect to connect
to the access point.
5
Connect the device to the access point.
For details about connecting, refer to the
operating instructions of the device.
6
Launch the Monitor & Control application
on a device and select the unit.
[Tip]
You can check the information required for
connecting to the unit using Network Setup >Show
Authentication (page 61) in the Network menu
of the full menu.
Advertisement
Table of Contents
