Table of Contents
Advertisement
117
7. Appendix: Troubleshooting
Wireless LAN Connection
[Note]
Obstructions and electromagnetic interference between the unit and wireless LAN access point or terminal device,
or the ambient environment (such as wall materials) could shorten the communication range or prevent connections
altogether. If you experience these problems, check the connection/communication status after moving the unit to a
new location, or bringing the unit and access point/terminal device closer together.
Symptom
Solution
A terminal device cannot access
• Check the wireless LAN connection (IP address, etc.).
the unit.
• The communication setting between the access point and client
You cannot log in to the unit.
Check the user name and password that you set.
Internet Connection
Symptom
Solution
File uploading fails.
The user name and password of the server may not be correct.
Input the correct user name and password.
File uploading is not available.
Signal condition may be poor.
Move to another location and try again.
When using the ND Filter
Symptom
Solution
The ND filter does not move.
You can move the filter to the Clear position manually using the
following procedure.
1
Set the ND STEP/VARIABLE switch (page 5) to the STEP position and press the down
button of the ND FILTER POSITION up/down button (page 4) so that the ND CLEAR lamp
turns on.
2
Turn the unit off.
may be invalid. For details, refer to the operating instructions of
the access point.
3
Remove the round cap (2 places) on the bottom side.
4
Insert a screwdriver in the hole (2 places) and turn it counterclockwise.
• The ND filter moves to the Clear position by turning counterclockwise. Continue turning
until reaching the Clear position.
• Use a screwdriver with ø2.4 mm diameter or smaller. The insertion depth of the
screwdriver is about 3.0 cm (1
3
/
in.).
16
Screwdriver hole
(with cap removed)
[Notes]
• Do not use the procedure above during normal operation. Only use this procedure if the ND filter will not move. The
ND filter may become damaged if this procedure is used during normal operation.
• After the procedure above is used, consult a Sony service center to have the unit repaired.
• If an error message still appears after performing the procedure above, shooting is still possible.
Advertisement
Table of Contents
