Table of Contents
Advertisement
No.
Part name
†
Fan motor
1) Perform work of item
2) Perform work of item
3) Loosen the set screw of the cross-flow fan
4) Take off fixing screws (2 pcs) to remove the
5) Pull out the fan motor outward.
‡
Cross-flow fan
1) Perform works of items
2) Take off fixing screws (2 pcs.) at the left side
3) Make the left side of the heat exchanger float
4) Loosen set screw of the cross-flow fan from
5) Take off fixing screws (2 pcs.) to remove the
Procedure
‚
.
ƒ
.
from the discharge port.
motor band (Right).
Drawing port of fan motor lead wires should be this position.
(
Determine the lead drawing port position so that motor band
(Right) does not come to contact with fan motor drawing port.
Draw out fan motor lead wire from here.
‚
of the end plate of the heat exchanger, and
then take off fixing screws (2 pcs.) of the
bearing base.
slightly, and then remove the bearing base.
the discharge port.
motor band (Right).
Motor band (Right)
Assemble the fan motor as shown below.
ƒ
and
.
* Remove set screw from gap of thermal
Fixing screws
insulator.
113
FILE NO. SVM-16045
Remarks
Motor band (Right)
)
Set screw
Cross-flow fan
Fixing
screws
Advertisement
Chapters
Table of Contents
Troubleshooting
