Service Note - Sony DSC-P1 Service Manual And Parts List
Hide thumbs
Also See for DSC-P1:
- Operating instructions manual (72 pages) ,
- Service manual (105 pages)
Table of Contents
Advertisement
• NOTE FOR REPAIR
Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
[Discharging of the ST-62 board's charging capacitor
(C1003)]
The charging capacitor (C1003) of the ST-62 board is charged up
to the maximum 300 V potential.
There is a danger of electric shock by this high voltage when the
battery is handled by hand. The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the unit is simply turned off. Therefore, the remaining
voltage must be discharged as described below.
Preparing the Short Jig
To preparing the short jig, a small clip is attached to each end of a
resistor of 1 kΩ /1 W (1-215-869-11).
Wrap insulating tape fully around the leads of the resistor to pre-
vent electrical shock.
Downloaded from
www.Manualslib.com
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
1 kΩ/1 W
Wrap insulating tape.
manuals search engine
SERVICE NOTE
Discharging the Capacitor
Short-circuit between the positive and the negative terminals of
charged capacitor with the short jig about 10 seconds.
– 5 –
R:1 kΩ/1 W
(Part code:
1-215-869-11)
Capacitor
Advertisement
Table of Contents
