AIR CONDITIONER (SPLIT TYPE) Owner’s Manual Wireless Remote Controller Kit Model name: For 2-way Air Discharge Cassette Type Owner’s Manual RBC-AX23UW(W)-E English Wireless Remote controller Kit 1 Manuel du proprietaire Français Kit de télécommande sans fil Wireless remote controller Generic model name and signal receiving part Betriebsanleitung RBC-AX23UW(W)-E...
Owner’s Manual Wireless Remote Controller Kit • Please read this Owner’s Manual carefully for correct use before using your Wireless Remote Controller Kit. Be sure to read “Precautions for Safety” • After you read this manual, please keep it with the Installation Manual of the air conditioner at accessible place.
If the remote controller is inappropriate installed by yourself, it may cause electric shock or fire, etc. • Make sure to install the air conditioner specified by TOSHIBA and ask the exclusive dealer when installing. If the air conditioner is installed by yourself, it may cause electric shock or fire, etc.
Owner’s Manual Wireless Remote Controller Kit Part Names and Functions Remote Controller (WH-H1JE2) • Up to 8 indoor units in a group can be controlled by one remote controller. RESET button Used after batteries are replaced or the slide switch is switched. (See page 10) Slide switch (See page 10) Battery compartment (See page 10) Cover...
Page 5
Owner’s Manual Wireless Remote Controller Kit Signal Receiving Part • The signal receiving part is attached to the The rear of signal receiving part indoor unit. The following switches are provided on the • Hereinafter, all remote controller button rear of the signal receiving part. For their names are indicated with respective settings, contact the dealer from whom you symbols displayed on the remote...
Page 6
Owner’s Manual Wireless Remote Controller Kit Display section All inticators are shown in the right and the lower figures for the explanation. Only selected contents are display in actual operation. Display • When turning on the leak breaker at the first time, [SET DATA] section flashes on the display part of the remote controller.
Owner’s Manual Wireless Remote Controller Kit Operation section Push each button to select a desired operation. • The details of the operation needs to be set up once, afterward, the air conditioner can be used by pushing ON/OFF only. SENSOR Mode button ON/OFF button Selects desired operation mode.
Owner’s Manual Wireless Remote Controller Kit Correct Usage Auto, Heat, Dry, Cool, Fan Stop Push • The automatic cooling/heating and The operation lamp goes off, and the heating functions are not provided for operation stops. In the COOL, DRY, or AUTO (cooling) mode, the fan runs for 10 minutes (or cooling only types.
Owner’s Manual Wireless Remote Controller Kit Timer Operation • After the timer has been set, put the <Usage Examples> remote controller at a position where ▼ Setting OFF timer signals of the remote controller can reach (Example) To stop operation in the signal receiver on the indoor unit.
Owner’s Manual Wireless Remote Controller Kit Louver Direction • While the air conditioner is not working, the louver (air direction adjusting plate) is closed automatically. • During the preparation for heating, the louver is directed upward and it starts swinging after the preparation for heating is canceled though the automatic louver display on the remote controller shows swinging even during this period.
Owner’s Manual Wireless Remote Controller Kit Slide Switch • The settings of operation mode display and air direction display vary as follows depending on the indoor unit in use. • Use a fine-tipped tool to change the switch setting. • Push the RESET button after the switch setting is changed. Louver display switch View with the cover removed SENSOR...
Owner’s Manual Wireless Remote Controller Kit Handle the Remote Controller • Point the transmitting part of the remote controller at the signal receiving part of the indoor unit. When a signal is received normally, “pi” sound is heard once. (“Pi, pi” is heard only at the beginning of operation.) •...
Owner’s Manual Wireless Remote Controller Kit Address Setting When two or more indoor units controlled by the same wireless remote controller are installed in a room, a unique address can be set for each indoor unit to prevent interference. Up to 6 indoor units can be controlled independently by the remote controller by matching the address switch setting of the signal receiving part with the address displayed on the remote controller.
Owner’s Manual Wireless Remote Controller Kit Emergency Operation In the event of an emergency shown below, push emergency operation on the signal receiving part (inside the ceiling panel or indoor unit) for emergency operation. • The batteries of the remote controller have been exhausted. •...
Owner’s Manual Wireless Remote Controller Kit Before Asking for Repair Work Check the following before asking for repair work. Check again Phenomenon Possible cause Measures Operation does The air conditioner is not working or a power failure Push on the remote controller again. not start even if has occurred.