4 Replacement Procedures
2. Disconnect the DC-IN jack cable from the connector CN8800 on the system board.
3. Peel off the glass tape and take out the HDD cable from the slot. (Be careful,
because the HDD cable is still connected to the connector on the back of the system
board.)
4. Disconnect the SmartCard unit cable from the connector CN2170 on the system
board.
5. Remove the system board while releasing two latches.
CN2170
SmartCard unit cable
(Sm
artCard model only)
4-54 [CONFIDENTIAL] TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633)
DC-IN jack
System board
Latch
Figure 4-33 Removing the system board
DC-IN jack cable
Glass tape
CN8800
HDD cable
Latch
Wireless communication switch
4.20 System board