Sony SLV-D370P Service Manual page 91
Dvd player/ video cassette recorder
Hide thumbs
Also See for SLV-D370P:
- Operating instructions manual (133 pages) ,
- Service manual (120 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
QQ
3 7 63 1515 0
6) Play back the Mono Scope alignment tape (SP mode).
7) Connect an oscilloscope CH-1 to the "Envelope" and CH-2 to the "H'D SW Pulse" for triggering.
8) Turn the guide roller heads with a flat head (
TE
L 13942296513
(3) Check Transitional Operation from RPS to Play
Check transition from RPS mode to play mode : Using a pre-recorded SP tape, make sure the entry side of envelope comes to an appropriate
steady state within 3 seconds (as shown in Fig. 6-12).
If the envelope waveform does not reach specified peak-to peak amplitude within 3 seconds, adjust as follows :
1) Make sure there is no gap between the supply roller lower flange and the tape.
If there is a gap, adjust the supply guide roller again.
2) Change operation mode from the RPS to the play mode (again) and make sure the entry side of envelope rises within 3 second.
www
.
http://www.xiaoyu163.com
) driver to obtain a flat video RF envelope as shown in Fig. 6-11.
S HEIGHT TOO HIGH
S HEIGHT TOO LOW
GUIDE ROLLER S
Fig. 6-11 Guide Roller S, T Height Adjustment
ENTRANCE SIDE ENVELOPE
x
ao
u163
y
Fig. 6-12 Video Envelope Rising when Operation mode Changes from RPS to Play Mode
i
http://www.xiaoyu163.com
2 9
8
IDEAL ENVELOPE
T HEIGHT TOO HIGH
Q Q
3
6 7
1 3
1 5
co
.
6-9
9 4
2 8
T HEIGHT TOO LOW
GUIDE ROLLER T
0 5
8
2 9
9 4
2 8
m
9 9
9 9
Hide quick links:
Advertisement
Table of Contents
