Table of Contents
Advertisement
2-8-5. MIC 1 IN Connector (CN-2615 Board)
1. Remove the inside panel and outside panel.
(Refer to Section 1-4.)
2. Remove the DC fan (front). (Refer to Section 2-5-1.)
3. Remove the four screws, and lift the sub frame
assembly.
4. Remove the two screws, and remove the CN-2615
board.
5. Disconnect the harness from the connector (CN3) on
the CN-2615 board.
6. Unsolder the MIC 1 IN connector from the CN-2615
board.
CN-2615
board
MIC 1 IN
connector
Unsolder
CN3
P2.6 x 5
B2.6 x 5
7. Install a new MIC 1 IN connector by reversing the
steps above.
HDC1000/V1(E)
B2.6 x 5
Sub frame assembly
2-8-6. REMOTE Connector (CN-2622 Board)
1. Remove the MIC panel assembly.
(Refer to Section 2-8-2.)
2. Remove the two screws, and remove the CN-2622
board.
3. Disconnect the harness from the connector (CN1) on
the CN-2622 board.
4. Unsolder the REMOTE connector from the CN-2622
board.
CN-2622
Unsolder
CN1
5. Install a new REMOTE connector by reversing the
steps above.
board
REMOTE
connector
MIC panel assembly
P2.6 x 5
2-15
Hide quick links:
Advertisement
Table of Contents
