Toshiba Satellite L20 Series User Manual page 9
Hide thumbs
Also See for Satellite L20 Series:
- User manual (256 pages) ,
- User manual (178 pages) ,
- Maintenance manual (264 pages)
Table of Contents
Advertisement
Notes for Users in Australia and New Zealand
Modem warning notice for Australia
Modems connected to the Australian telecoms network must have a valid
Austel permit. This modem has been designed to specifically configure to
ensure compliance with Austel standards when the country/region selection
is set to Australia. The use of other country/region setting while the modem
is attached to the Australian PSTN would result in you modem being
operated in a non-compliant manner. To verify that the country/region is
correctly set, enter the command ATI9 which displays the currently active
setting.
To set the country/region permanently to Australia, enter the following
command sequence:
Failure to set the modem to the Australia country/region setting as shown
above will result in the modem being operated in a non-compliant manner.
Consequently, there would be no permit in force for this equipment and the
Telecoms Act 1991 prescribes a penalty of $12,000 for the connection of
non-permitted equipment.
Notes for use of this device in New Zealand
■
The grant of a Telepermit for a device in no way indicates Telecom
acceptance of responsibility for the correct operation of that device
under all operating conditions. In particular the higher speeds at which
this modem is capable of operating depend on a specific network
implementation which is only one of many ways of delivering high
quality voice telephony to customers. Failure to operate should not be
reported as a fault to Telecom.
■
In addition to satisfactory line conditions a modem can only work
properly if:
a/ it is compatible with the modem at the other end of the call and
b/ the application using the modem is compatible with the application
■
This equipment shall not be used in any manner which could constitute
a nuisance to other Telecom customers.
■
Some parameters required for compliance with Telecom's PTC
Specifications are dependent on the equipment (PC) associated with
this modem. The associated equipment shall be set to operate within
the following limits for compliance with Telecom Specifications:
a/ There shall be no more than 10 call attempts to the same number
b/ The equipment shall go on-hook for a period of not less than 30
c/ Automatic calls to different numbers shall be not less than 5
User's Manual
AT+GCI=09
at the other end of the call - e.g., accessing the Internet requires
suitable software in addition to a modem.
within any 30 minute period for any single manual call initiation, and
seconds between the end of one attempt and the beginning of the
next.
seconds apart.
TOSHIBA L20 Series
ix
Hide quick links:
Advertisement
Table of Contents
