Table of Contents
Advertisement
Installing the battery pack
To install a battery pack, follow the steps as detailed below:
Do not touch the battery release latch while holding the computer or the
battery pack might fall out due to the unintentional release of the battery
release latch and cause injuries.
1.
2.
3.
Power-up modes
The computer has three different power-up modes as follows:
Please refer to the sections
power
Windows utilities
You can configure various settings associated with both Sleep Mode and
Hibernation Mode within the Power Options (to access it, Start -> Control
Panel -> System and Security -> Power Options).
Hot keys
You can use the FN + F3 hot key to enter Sleep Mode or FN + F4 to enter
Hibernation Mode.
Panel power on/off
You can set up your computer so that power is turned off automatically
when you close the display panel, and turned on again when you open it.
Please note that this function is only available for Sleep Mode or
Hibernation Mode, not for Shut Down Mode.
If the panel power off function is enabled, and you manually shut down
Windows, do not close the display panel until the shut down process has
been completed.
User's Manual
Insert the battery pack as far as it will go into the computer.
Ensure that the battery pack is securely in place and the battery safety
lock is in its locked position.
Turn your computer over.
Shut Down Mode: The computer will shut down without saving data -
in view of this you must always save your work before you turn the
computer off.
Hibernation Mode: Data in memory will be saved to the hard disk
drive.
Sleep Mode: Data will be maintained in the computer's memory.
in Chapter 1, Getting Started for further information.
Turning on the power
Qosmio F750 Series
and
Turning off the
5-9
- Quick Links:
- Internal Hardware Components
- System Recovery
Hide quick links:
Advertisement
Table of Contents
