Table of Contents
Advertisement
How to reset the passwords
This section describes how to reset the supervisor and user password.
Supervisor password
Go to the DOS prompt, type in SVPW, and press Enter.
1.
If the password has been registered, the following line will be displayed:
2.
Press Y to delete the password. The following line will be displayed:
3.
Enter the currently registered password. The character string you enter
4.
is displayed as a string of asterisks. For example, if you enter a
password consisting of four characters, the display is shown as:
Press Enter. If character strings match, the password is deleted and
5.
the display changes to:
If they do not match, the following message appears:
Press Y to return to step 3. Press N to return to DOS.
If you enter the password incorrectly three times, the screen displays:
Password access denied!
You will not be able to access the SVPW program. In this case you must
turn the power off and back on to retry the procedure.
Follow the same procedures described in the earlier section, How to
6.
set the passwords, to set a new supervisor password.
After you register or delete a supervisor password, if you press the reset
switch before turning off the power, your latest supervisor password setting
will be cancelled.
A switch on the supervisor's password command lets you enable or
7.
disable TSETUP access in user password mode. Refer to the section
Enabling TSETUP access in user password mode in this chapter.
7-18 Setup and Password Security
SUPERVISOR PASSWORD = Registered
Do you want to delete the supervisor
password <Y/N>?
Enter Password --->
Enter Password ---> ****
SUPERVISOR PASSWORD = Not Registered
Password verify error!
Do you want to retry <Y/N>?
User's Manual
- Quick Links:
- Features
Hide quick links:
Advertisement
Table of Contents
