Table of Contents
Advertisement
2-2. EXCHANGE METHOD OF BARRIER ASSY
Service parts
Part Number
1
2-673-650-01
Ring (A), Ornamental
2
2-673-652-01
Barrier Assy
3
2-673-651-01
Tapping screw (B1.2 4)
Tools used
Torque driver
Soldering iron
Weight about 60g
Adhesive tape (ornamental ring fixed) (2-677-885-01)
2-2-1. PEEL OFF OLD ORNAMENTAL RING A
The Ornamental Ring A has adhered to the Barrier Assy strongly and accordingly, use a soldering iron to weaken the adhesive force.
Heat four circled portions with the soldering iron.
Heating temperature is about 300ºC.
Beware of a burn since the entire Ornamental Ring becomes hot.
* As the adhesive force of Ornamental Ring A is considerably large, the forced peeling will damage the group-1 frame.
Insert the tip of tweezers, etc. into a notch of the group-1 frame and prize the ring.
* Take extreme care so as not to damage the coated surface of the group-1 frame.
In case of difficult peeling, heat the ring again with the soldering iron.
If this re-heating failed, it may be advisable that the ring be peeled while heating the portions 1
sequentially.
* Discard the removed Ornamental Ring A.
DSC-W30/W40_L2
Part Name
Quantity
1
2
Tip
1
1
2
2-6
1
2
3
2 in the under figure one by one
Hide quick links:
Advertisement
Table of Contents
