Table of Contents
Advertisement
Troubleshooting
The camera is a microcomputer-controlled
device. External noise and interference (from
a TV, a radio, etc.) might prevent it from
functioning properly.
The following phenomena are not
malfunctions.
•
The camera heats up when it is used for a
long time.
•
The battery heats up during charging.
•
When playing back a video fi le, the
image stops momentarily or the sound is
interrupted at junctions between scenes.
Trouble
No power is supplied.
No display appears.
The power was turned
off accidentally.
The displayed amount
of remaining battery
power differs from the
actual operating time.
The power does not
turn on, or the battery
operation time is
extremely short even
after the battery is
fully charged.
The access/charge
lamp on the camera
does not light during
charging.
•
To solve the problem, fi rst follow the
instructions below.
•
If the problem is not solved, reset the
camera. (
•
If the problem persists, please consult your
nearest JVC dealer.
8 To reset the camera
•
Connect the AC adapter securely.
•
Detach the battery pack once and re-attach it fi rmly.
•
Replace the dead battery with a fully charged one.
•
If the camera is not operated for 5 minutes while the
power is on, it turns itself off automatically to conserve
power. To turn the camera on again when using the
battery pack, set the power/mode switch to OFF, then to
ON. When using the AC adapter, perform any operation
such as zooming.
•
Adjust the brightness of the LCD monitor.
•
Move to a place where not affected by vibration or
excessive sound.
•
The drop detection function operated. Set the power/
mode switch to OFF, and to ON again. To turn off this
function, set [DROP DETECTION] to [OFF].
•
Fully charge the battery, and then run it down. If the
problem persists, the battery is worn out and needs to be
replaced. Please purchase a new one.
•
Make sure to use the camera under appropriate operating
temperatures.
•
The battery is worn out and needs to be replaced. Please
purchase a new one.
•
Charging may stop in places subject to extremely
high/low temperatures to protect the battery. It is
recommended to charge it in places with a temperature
of 10°C to 35°C.
•
When the battery is already fully charged, the lamp does
not light. Check the remaining battery power.
below)
1) Set the power/mode switch to OFF and
remove the power supply (battery pack
or AC adapter) from the camera, then
reattach it.
2) Execute [PRESET] from the menu.
(
pg. 69)
Action
16
16
–
–
69
–
69
16
79
–
–
18
73
Advertisement
Table of Contents
