Related Manuals for Toro 66200
Summary of Contents for Toro 66200
- Page 1 Form No. 3446-530 Rev C Revolution 60V Backpack and Blower Cannon Tool Model No. 66200—Serial No. 323000001 and Up Model No. 66200T—Serial No. 323000001 and Up *3446-530* Register at www.Toro.com. Original Instructions (EN)
- Page 2 Toro 60V lithium-ion battery chargers. Using these products for purposes other than their intended uses could prove dangerous to you and bystanders. Model 66200 does not include a battery or a charger. g377663 Model 66200T only includes the blower cannon, it does not include the backpack.
-
Page 3: Safety Alert Symbol
II. Preparation Keep bystanders and children away from the operating area. Use only the battery pack specified by Toro. Using other accessories and attachments may increase the risk of injury and fire. Plugging the battery charger into an outlet that is not 100 to 240 V can cause a fire or electric shock. - Page 4 Charge the battery pack with only the battery power tool for your application. The correct charger specified by Toro. A charger suitable for power tool will do the job better and safer at the 1 type of battery pack may create a risk of fire rate for which it was designed.
- Page 5 connection from 1 terminal to another. Shorting the battery terminals may cause burns or a fire. Keep your hands and feet away from moving parts. Shut off the tool, remove the battery pack from the backpack, and wait for all movement to stop before adjusting, servicing, cleaning, or storing the backpack or tool.
-
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal145-2340 decal145-2339 145-2340 145-2339 1. Warning—read the 3. Thrown object 1. - Page 7 decal145-3805 145-3805 1. Warning—read the 2. Do not dispose improperly. Operator’s Manual; stay away from moving parts; keep all guards and shields in place; wear eye protection; do not expose to rain. decal145-3809 145-3809 1. The battery pack is over 2.
-
Page 8: Assembling The Blower Tubes
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Blower cannon Middle tube section Assemble the blower tubes. Nozzle section Backpack Install the blower cannon. Blower cannon assembly Assembling the Blower Tubes Slide the channels of the middle blower tube section over the posts on the blower tube cylinder, and rotate the middle section to secure it (A of Figure... -
Page 9: Product Overview
Installing the Blower Product Overview Cannon to the Backpack Note: The backpack can also be used to power other tools using the backpack tether Model 66005 (not included). Align the blower cannon with the backpack power connection (Figure g366972 Figure 6 1. -
Page 10: Specifications
Contact your Authorized Service Dealer or authorized Toro distributor or go to www.Toro.com for a list of all approved attachments and accessories. To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. - Page 11 Pull down on the shoulder strap adjuster until the straps are snug (Figure 11). g377912 Figure 9 1. Sternum strap adjuster 3. Hip belt adjuster and and buckle buckle g377918 Figure 11 2. Shoulder strap adjuster Connect and adjust the height of the sternum Tighten the sternum strap so that it is snug strap.
- Page 12 Adjusting the Blower Grip If the hip belt is too tight, push sideways on the adjuster to lengthen the straps (Figure 14). Position The blower grip position is adjustable; while wearing the backpack, do the following: Loosen the blower grip knob by turning it counterclockwise.
-
Page 13: Starting The Blower
Starting the Blower Set the backpack down on a level surface. Pull up on the latch tabs to open the latches securing the battery cover and set the cover WARNING aside. The blower can throw debris, possibly Line up the cavity on the back of the battery with causing serious personal injury to you or either of the battery ports in the backpack. - Page 14 Shutting Off the Blower To start the blower, squeeze the variable-speed trigger (Figure 20). To shut off the blower, disengage the speed lock (if in Note: Engage the speed lock to keep the use) and release the variable-speed trigger (Figure machine on without pressing the variable-speed 21).
- Page 15 Removing the Batteries Removing the Blower from the Backpack Cannon from the Backpack Set the backpack down on a level surface. Press the blower latch button and pull up on the blower cannon to separate it from the backpack (Figure 23).
- Page 16 Storage Important: Store the tool, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page 10). Important: If you are storing the battery pack for the off-season, remove the battery pack from the tool and charge the battery pack until 2 or 3 LED indicators turn green on the battery.
-
Page 17: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action An LED indicator light on the backpack is 1. - Page 18 Notes:...
- Page 19 The Toro Company (“Toro”) respects your privacy. When you purchase our products, we may collect certain personal information about you, either directly from you or through your local Toro company or dealer. Toro uses this information to fulfil contractual obligations - such as to register your warranty, process your warranty claim or to contact you in the event of a product recall - and for legitimate business purposes - such as to gauge customer satisfaction, improve our products or provide you with product information which may be of interest.