Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bosch SMV65U60
Summary of Contents for Bosch SMV65U60
- Page 1 SM… SB…...
-
Page 3: Table Of Contents
Table of contents Intended use ....4 Utensils ....13 Not suitable. -
Page 4: Intended Use
Intended use Optical display while the Intended use programme is running ... 22 Remaining running time display ..23 I n t e n d e d u s e Timer programming . -
Page 5: Delivery
Safety instructions Delivery The electrical connection conditions must correspond 1. Check the packaging and with the specifications dishwasher immediately for on the dishwasher rating plate 9J. damage caused in transit. Do not switch on a damaged If the power cord of this appliance, but contact your appliance is damaged, supplier. -
Page 6: In Daily Use
Safety instructions If you cannot obtain any In daily use information from Read and observe the safety the manufacturer, you must information and instructions not install the dishwasher for use on the packaging above or below these for cleaning and rinsing agents. appliances. - Page 7 Safety instructions Warning Warning Risk of injury! Risk of scalding! Open the door carefully when To prevent injuries, e.g. the programme is still running. caused by stumbling, open There is a risk of hot water the dishwasher only briefly spraying out of the appliance. in order to load and unload the dishwasher.
-
Page 8: Protection Of The Environment
Protection of the environment When opening and closing Protection of the the door on an eye-level environment appliance, ensure that children do not become i o n P r o t e c t o f t e n v i r o n m e n t jammed or crushed between Both the packaging of new appliances and the old appliances themselves... -
Page 9: Getting To Know Your Appliance
Getting to know your appliance Appliance interior Getting to know your appliance 1" Interior light * G e t t i t o k n o w y o u r a p p l i a n c 1* Top basket Diagrams of the control panel 12 Knife shelf * and the interior of the appliance can be... -
Page 10: Water Softening System/Special Salt
Water softening system/Special salt To change the setting: Water softening 1. Press programme button 3. system/Special salt Each time the button is pressed, the set value increases by one level; W a t e r s o f t e n i s y s t e m / S p e c i s a l t when the value of :... -
Page 11: Detergents With Salt Component
Rinse aid 1. Open the screw-type cap of the Switching off salt refill compartment 1b. indicator/water softening 2. Fill the tank with water (only required system when switching on the appliance for S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m the first time). -
Page 12: Setting Amount Of Rinse Aid
Rinse aid 1. Open the dispenser 92 by pressing 1. Open the door. and lifting the plate on the cover. 2. Switch on ON/OFF switch (. 3. Hold down programme button # and press START button )" until : ..is indicated on the digital display. -
Page 13: Utensils
Utensils Loading the dishwasher Utensils U t e n s i 1. Remove large food remnants. It is not necessary to prerinse utensils Not suitable under running water. 2. Place the utensils so that Cutlery and utensils made of wood. –... -
Page 14: Cups And Glasses
Utensils Cups and glasses Pans Top basket 1* Bottom basket 9* Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 1B. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully. -
Page 15: Cutlery Basket
Utensils Cutlery basket F olding spikes * F o l d i n g s p i k e s You should always place cutlery * depending on model unsorted with the points downwards. The spikes can be folded down to To prevent injuries, place long, pointed improve arrangement of pans, bowls implements and knives on the knife... -
Page 16: Knife Shelf
Utensils Knife shelf * Top basket with side levers K n i f e s h e l f 1. Pull out the top basket 1* out. * depending on model 2. To lower the basket, press in the left Long knives and other utensils can be and then the right lever on the arranged horizontally. -
Page 17: Detergent
Detergent Adding detergent Detergent 1. If the detergent dispenser 9: is still D e t e r g e closed, press the lock 9B to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing up liquid. -
Page 18: Combination Detergent
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect... -
Page 19: Overview Of Programmes
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia. -
Page 20: Information For Test Institutes
Additional options Information for test institutes HygienePlus * H y g i e n e P l u s Test institutes receive the information for This function increases the temperatures comparability tests (e.g. according to and retains them for an extra long time EN60436). -
Page 21: Operating The Appliance
Operating the appliance Zeolith drying Operating the appliance The appliance features a Zeolith container Zeolith is a mineral which can O p e r a t i i a n c e t h e a p p l store moisture and heat energy and release them again. -
Page 22: Switching On The Appliance
Operating the appliance Switching on the appliance Possible settings of the optical display: 1. Turn on the tap fully. The display is switched off. 2. Open the door. Programme, timer programming, 3. Switch on ON/OFF switch (. remaining time, end of programme and, if required, low water level are The Eco 50°... -
Page 23: Remaining Running Time Display
Operating the appliance Remaining running time End of programme display The end of the programme O / : displayed on the floor – provided the When the programme is selected, the optical display is switched on and is programme running time is indicated visible. -
Page 24: Automatic Switch Off / Interior Light
Operating the appliance Automatic switch off after end To change the setting: 1. Press programme button 3. of programme or interior light* A u t o m a t i c s w i t c h o f f / i n t e r i o r l i g h t Each time the button is pressed, the set value increases by one level;... -
Page 25: Terminating The Programme
Cleaning and maintenance 3. To continue the programme, switch 4. Release both buttons. on the ON/OFF switch ( again. The LED for button # flashes and the digital display 8 displays the 4. Close the door. factory setting : 5. Press programme button # until T erminating the programme the factory set value : T e r m i n a t i n g t h e p r o g r a m m e... -
Page 26: Special Salt And Rinse Aid
Cleaning and maintenance To ensure that the door seal always Filters remains clean and hygienic, regularly clean it with a damp cloth and a little The filters 1j keep large foreign washing-up liquid. objects in the rinsing water away from If the appliance is switched off for the pump. -
Page 27: Spray Arms
Fault, what to do? Spray arms Fault, what to do? F a u l t , w h a t d o ? Limescale and contaminants in the rinsing water may block nozzles and Experience has shown that you can bearings on the spray arms 1: and rectify most faults which occur in daily operation yourself. -
Page 28: Waste Water Pump
Fault, what to do? Waste water pump 6. Check impeller wheel and remove any foreign objects. 7. Place cover in the original position Large food remnants or foreign objects and press down until it engages which were not captured by the filters (click). -
Page 29: Fault Table
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display @ lights up. Tap turned off. Turn the tap on. Tap jammed or calcified. Turn the tap on. Flow rate must be min. - Page 30 Fault, what to do? Fault Cause Remedial action A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (. After a short time restart the indicated on the digital occurred. display. appliance. to : If the problem recurs, turn off the tap and pull out the mains plug.
- Page 31 Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid in the Refill rinse aid. dispenser. Programme selected without Select programme with drying (see drying. “Overview of programmes”, “Programme sequence”). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
- Page 32 Fault, what to do? Fault Cause Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
- Page 33 Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts. surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
- Page 34 Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting of Can be partly removed with machine brown), difficult to remove ingredients from vegetables (e.g. cleaner or by mechanical cleaning. Coatings to non-removable coatings cabbage, celery, potatoes, are harmless.
- Page 35 Fault, what to do? Fault Cause Remedial action Initial or existing, Glasses not dishwasher-proof, Use dishwasher-proof glasses. irreversible clouding of only suitable for dishwasher. Avoid long steam phase (standing time after glass. wash cycle ends). Use wash cycle at lower temperature. Set water softening system according to the water hardness (if required one setting lower).
- Page 36 Fault, what to do? Fault Cause Remedial action Detergent residue in the Spray arms blocked by utensils, Ensure that the spray arms can rotate freely. detergent dispenser or in therefore detergent is not rinsed the tablet collecting tray. out. The detergent dispenser was Pour detergent into the dry detergent damp when filled.
-
Page 37: Customer Service
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service. -
Page 38: Delivery
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains. -
Page 39: Drinking Water Connection
Installation and connection Drinking water connection Setting hot water: 1. Open the door. 2. Switch on ON/OFF switch (. 1. Fasten the drinking water connection to the tap according 3. Hold down programme button # to the installation instructions using and press START button )"... -
Page 40: Removing The Appliance
Installation and connection 5. Press START button )". Use only a residual current operated circuit-breaker which features 6. Close the door. the symbol ‚. Only this extension Programme sequence starts. guarantees compliance with 7. Open door after approx. 4 minutes. the currently valid regulations. - Page 42 *9000786517* 9000786517 en (9411) 640TV...