Safety instructions Children must not play with, on, Delivery or around the appliance. 1. Check the packaging and Children must not clean the dishwasher immediately for appliance or carry out general damage caused in transit. Do maintenance unless they are at not switch on a damaged least 8 years old and are being appliance, but contact your...
Page 6
Safety instructions The electrical connection If you cannot obtain any conditions must correspond information from with the specifications the manufacturer, you must on the dishwasher rating not install the dishwasher plate 92. above or below these appliances. If the power cord of this appliance is damaged, If you install a microwave it must be replaced with...
Safety instructions In daily use Disposal Read and observe the safety 1. Make redundant appliances information and instructions unusable to prevent for use on the packaging subsequent accidents. for cleaning and rinsing agents. 2. Dispose of the appliance in a n environmentally friendly manner.
Page 8
Safety instructions Keep children away from Warning open dishwasher. There may Risk of explosion! be small parts in the Do not add any solvents dishwasher which children to the washing chamber. could swallow and the water Danger of explosion! inside the dishwasher is not drinking water as it may Warning contain detergent residue.
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c...
Water softening system/Special salt Appliance interior Water softening system/Special salt 1" Top basket W a t e r s o f t e n i s y s t e m / S p e c i s a l t 1* Knife shelf * To ensure good washing results, 12 Tablet collecting tray...
Water softening system/Special salt Setting 5. Press and hold down the START button @. 6. Rotate programme selector 8 until The amount of salt dispensed can be the salt refill indicator ` flashes. set in 4 stages depending on the hardness of your 7.
Rinse aid Using special salt S witching off salt refill S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m indicator/water softening Always refill with special salt system...
Rinse aid 1. Open the dispenser 1j by pressing Setting amount of rinse aid and lifting the plate on the cover. The amount of rinse aid dispensed can be set in 4 stages. Accordingly 0, 1, 2 or 3 displays are lit (see water hardness table).
Utensils Loading the dishwasher Utensils U t e n s i 1. Remove large food remnants. It is not necessary to prerinse utensils Not suitable under running water. 2. Place the utensils so that Cutlery and utensils made of wood. –...
Utensils Cups and glasses Pans Top basket 1" Bottom basket 1b Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 12. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully.
Utensils Cutlery basket Small accessories holder * S m a l l a c c e s s o r i e s h o l d e r You should always place cutlery * depending on model unsorted with the points downwards. Light-weight plastic accessories, e.g.
Utensils A djusting the height of the 3. To raise the basket, hold the basket A d j u s t i n g t h e h e i g h t o f t h e b a s k e t on the sides of the upper edge and basket * lift it up.
Detergent Adding detergent Detergent 1. If the detergent dispenser 9" is still D e t e r g e closed, press the lock 9* to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing up liquid.
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect...
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options Additional options o n a l A d d i t i o p t i o n s Programme selection * depending on model Additional options can be set with You can select a suitable programme the buttons P. according to the type of utensils and degree of soiling.
Operating the appliance · Hygiene * Operating H y g i e n e the appliance The temperature is increased during the cleaning process. This increases the O p e r a t i i a n c e t h e a p p l hygiene status.
Operating the appliance Switching on the appliance End of programme 1. Turn on the tap fully. The programme has ended when neither of the two displays )" or )* is 2. Close the door. lit. 3. Switch on ON/OFF switch (. The Cleaning display )* flashes.
Cleaning and maintenance Intensive drying Cleaning and maintenance The final rinse uses a higher temperature which improves the drying C l e a n i a n d m a i n t e n a n c e result. The running time may increase A regular inspection and maintenance slightly.
Cleaning and maintenance Never use a steam cleaner to clean your Filters dishwasher. The manufacturer is not liable for any consequential damage. The filters 1R keep large foreign Regularly wipe the front of the appliance objects in the rinsing water away from and fascia with a damp cloth;...
Fault, what to do? Spray arms Fault, what to do? F a u l t , w h a t d o ? Limescale and contaminants in the rinsing water Experience has shown that you can may block nozzles rectify most faults which occur in daily and bearings on the spray arms 1: operation yourself.
Fault, what to do? Waste water pump 6. Check impeller wheel and remove any foreign objects. 7. Place cover in the original position Large food remnants or foreign objects and press down until it engages which were not captured by the filters (click).
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display h lights up. Tap turned off. Turn the tap on. Tap jammed or calcified. Turn the tap on. Flow rate must be min.
Page 29
Fault, what to do? Fault Cause Remedial action Displays flash. Door not closed properly. Close the door. Ensure that no objects (utensil, fragrance dispenser) are protruding over the basket and preventing the door from closing. Refill indicator for salt ` No rinse aid.
Page 30
Fault, what to do? Fault Cause Remedial action Cutlery not dry. Cutlery not arranged properly in Separate cutlery if possible, prevent contact the cutlery basket. points. Cutlery not arranged properly in Arrange cutlery properly and separate if the cutlery drawer. possible.
Page 31
Fault, what to do? Fault Cause Remedial action Detergent residue. Detergent dispenser cover Detergent dispenser cover must not be blocked by utensils and therefore obstructed by utensils. does not open fully. Do not place utensils or fragrance dispenser in the tablet collecting tray. Detergent dispenser cover Tablet must be inserted flat and not upright.
Page 32
Fault, what to do? Fault Cause Remedial action White, stubborn coatings; Detergent substances are Change detergent brand. limescale on the utensils, deposited. These coatings cannot Clean appliance mechanically. container or door. usually be removed with chemicals (appliance cleaner, ...). Hardness range incorrectly set or Set water softening system according to water hardness greater than 8.9 instructions for use or top up salt.
Page 33
Fault, what to do? Fault Cause Remedial action Plastic parts discoloured. Too low rinsing temperature. Select programme with higher washing temperature. Utensils precleaned too intensely; Do not prerinse utensils. Remove only large sensors therefore decide on food remnants. weak programme sequence. Recommended programme Eco 50°...
Page 34
Fault, what to do? Fault Cause Remedial action Appliance does not start. The mains fuse has tripped. Check mains fuse. Power cord not inserted. Ensure that the power cord is plugged all the way into the back of the appliance and into the socket.
Page 35
Fault, what to do? Fault Cause Remedial action Knocking or rattling noise. Spray arm strikes the utensils, Position utensils so that the spray arms do utensils not positioned correctly. not strike the utensils. If there is a low load, the water Load the appliance with more utensils or jets strike the washing tank distribute the utensils more evenly in the...
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service.
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains.
Installation and connection Waste-water connection Drinking water connection 1. The required work sequence can be 1. Fasten the drinking water connection found in the installation instructions. to the tap according If required, fit a siphon with an to the installation instructions using drainage connection.
Installation and connection Electrical connection Removing the appliance Connect the appliance to an Also observe alternating current only, ranging from the sequence of worksteps here. 220 V to 240 V and 50 Hz or 60 Hz 1. Disconnect the appliance from via a correctly installed socket with the power supply.
Installation and connection Transportation Protection against frost P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e ) Empty the dishwasher and secure loose If the appliance is in a room where there parts.
Page 42
*9000830553* 9000830553 en (9509) 440EA...