Advertisement
E2TC2BD_EN.book Page 74 Thursday, May 7, 2009 9:02 AM
Symptom
TV channels cannot be changed.
Some settings are lost even though you
followed the procedure correctly.
Only specific channels do not appear.
Though auto tuning was completed,
you cannot watch the DVB and
analogue channels.
The TV channel which you have been
able to watch before has disappeared
and "No signal" is displayed.
The image from the external device
cannot be displayed.
Recording is impossible.
Timer recording cannot be
performed.
Recording is impossible.
"Repairing" appears on the TV
screen.
Repairing
In a case you intend to cancel the
repairing process.
Do you want to cancel a repairing
process? When selecting "Yes",
the disc may not be usable.
Yes
No
Repairing
The indication
"
Writing to Disc
does not disappear.
74
EN
• Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Try "Channel" setting by following the steps on pages 20-22.
• If you unplug the AC mains cable while the warning message, "Saving settings.
Please wait.", is displayed, some settings may be lost. Do not unplug the AC
mains cable while the message is displayed (It will take about 1 minute.).
• The channels may be set to be skipped. (See pages 22, 24.)
• Confirm whether an antenna cable is connected correctly and try to tune again.
(See pages 20-26.)
• If you move the unit to a different area, you will need to perform auto tuning
again.
• Try pressing [INPUT SELECT F] repeatedly to select the external input
channel, then press [PROG. G \ H] repeatedly to select your desired
channel.
• Turn on all connected devices.
• Check if the connections are made securely and correctly.
• It is prohibited to make a recording from 2 minutes before the programmed start
time of a timer recording.
• This unit cannot record programmes that contain copy protection signal. This is
not a malfunction.
• The space of the recording media may be used up. Try deleting unnecessary
titles, or exchange it with the recordable media.
• The maximum number of titles or chapters has exceeded. Delete the
unnecessary titles to make enough space or insert a new recordable media.
• Check if the connections are made securely and correctly.
• The internal clock of the unit may have been stopped due to a power failure that
lasted for more than 30 seconds. Reset the clock. (See page 70.)
• Check if the disc is CPRM compatible. Copy-once programmes can only be
copied onto the disc which is CPRM compatible.
• Check if the disc is protected or finalised. Undo the protection or the finalisation.
• Video mode DVD-RW once formatted in other unit cannot be recorded in this
unit unless formatted in this unit.
• Check if the connections are made securely and correctly.
• If there is a power failure or unplugging during recording, finalising, formatting or
editing (even after "Repairing" disappears), a repairing process will begin
automatically just after turning the unit on again.
• It may take several minutes up to about several hours.
• If you intend to cancel the repairing process, press [A OPEN\CLOSE] on the
front panel, then select "Yes" and press [ENTER\OK]. After that, press
[OPEN\CLOSE A] to take out the disc. The disc cancelled during the repairing
process MAY NOT work.
• "
Writing to Disc
"
20 seconds even after it reached 100%. This is not a malfunction.
100%
Remedy
" may remain on screen for the maximum of
100%
Advertisement
