Error Messages - Sony STR-DA3300ES Operating Instructions Manual
Multi channel av receiver
Hide thumbs
Also See for STR-DA3300ES:
- Operating instructions manual (294 pages) ,
- Service manual (242 pages) ,
- Technical bulletin (7 pages)
Table of Contents
Advertisement
Remote control
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure that the command modes of the
receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 37).
• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
Error messages
If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
PROTECTOR
Irregular current is output to the speakers, or
the upper panel of the receiver is covered
with something. The receiver will
automatically turn off after a few seconds.
Check the connection of speakers and turn
on the power again.
For other messages, refer to "Message list after
auto calibration measurement" (page 48) and
"DIGITAL MEDIA PORT message list"
(page 84).
116
GB
Reference sections for clearing
the memory
To clear
All memorized settings
See
page 36
Hide quick links:
Advertisement
Table of Contents
