Related Manuals for Toshiba LA2B Series
Summary of Contents for Toshiba LA2B Series
- Page 1 32/43 LA2B Series 32/43 LA3B Series 32/43 WA2B Series 32/43 WA3B Series OPERATING INSTRUCTIONS...
-
Page 2: Table Of Contents
Table of Contents CEC ...............25 Google Cast............25 Safety Information ..........2 HBBTV System............26 IMPORTANT - Please read these instructions fully Quick Standby Search ...........26 before installing or operating ......2 Software Update ............26 Markings on the Product ........2 Troubleshooting & Tips ..........27 WARNING ............3 VGA Input Typical Display Modes ......28 WALL MOUNTING WARNINGS ......3... -
Page 3: Safety Information
• Do not expose the TV to direct sunlight or do Safety Information not place open flames such as lit candles on the top of or near the TV. • Do not place any heat sources such as electric CAUTION heaters, radiators, etc. -
Page 4: Warning
electrical isolation below a certain frequency range WARNING (galvanic isolator) Do not ingest the battery, Chemical Burn Hazard WALL MOUNTING WARNINGS This product or the accessories supplied with the • Read the instructions before mounting your TV on product may contain a coin/button cell battery. If the the wall. -
Page 5: Introduction
Introduction Stand Installation & Wall Mounting Thank you for choosing our product. You’ll soon be enjoying your new TV. Please read these instructions Assembling / Removing the pedestal carefully. They contain important information which will help you get the best from your TV and ensure safe Preparations and correct installation and operation. -
Page 6: Antenna Connection
Antenna Connection Connect the aerial or cable TV plug to the AERIAL INPUT (ANT) socket or satellite plug to the SATELLITE INPUT (LNB) socket located on the rear side of the TV. Rear side of the TV 1. Satellite 2. Aerial or cable If you want to connect a device to the TV, make sure that both the TV and the device are turned off before making any connection. -
Page 7: Other Connections
Other Connections If you want to connect a device to the TV, make sure that both the TV and the device are turned off before making any connection. After the connection is done, you can turn on the units and use them. To enable VGA/Component audio, Connector Type... -
Page 8: Turning On/Off The Tv (Optional)
To switch the TV into standby Turning On/Off the TV (optional) The TV cannot be switched into standby mode via control switch. Press and hold the Standby button on Connect power the remote control. Power off dialogue will appear on the screen. -
Page 9: Tv Control & Operation (Optional)
Press the control button again to go back to operating button to switch to different sources when in Live TV mode. mode. Or enter the Inputs menu on the Home Screen, select the desired source from the list and press OK. Changing Channels and Volume TV Control &... - Page 10 mode. Or enter the Inputs menu on the Home Screen, You can adjust the volume by using the Volume select the desired source from the list and press OK. +/- buttons and change the channel in Live TV mode by using the Programme +/- buttons on the remote. Changing Channels and Volume You can adjust the volume by using the Volume +/- buttons and change the channel in Live TV mode...
-
Page 11: Remote Control
Remote Control Standby: Quick Standby / Standby / On Numeric buttons: Switches the channel in Live TV mode, enters a number or a letter in the text box on the screen Language: Switches among sound modes (analogue TV), displays and changes audio language (digital TV, where available) Volume +/- Microphone: Activates the microphone on the remote... -
Page 12: Initial Setup Wizard
to a Google account in order to use Google services. Initial Setup Wizard This step will be skipped if no internet connection has been established in the previous step or if you already Note: Follow the on-screen instructions to complete the initial signed in to your Google account in Quick Setup step. - Page 13 later using the Settings>Device Preferences>Usage the desired operator and press OK or the Right & Diagnostics menu on the Home Screen. directional button to proceed. On the next screen select Scan option to start a search or select Skip Information on Google services and some features of Scan to continue without performing a search.
-
Page 14: Home Screen
satellite and to enable scan this option should be set The available options of the Home Screen are posi- as On first. Press Back button and select next satellite tioned in rows. To navigate through the Home Screen you want to set. After you completed the configuration options use the directional buttons on the remote. -
Page 15: Tv Options
environment and preferences if necessary. You list. Highlight a channel and press OK to make a can use the Channel menu options to search for selection. Selected channel will be displayed, every broadcast channels. Refer to the Channel section time the TV is turned back on from quick standby for more information. -
Page 16: Record (Optional)
Teletext Time Shift Mode: Enable or disable timeshift recording feature. Refer to USB Recording section for more Digital Teletext Language: Set the teletext information. language for digital broadcasts. Decoding Page Language: Set the decoding Settings page language for teletext display. BISS Key: “Click To Add Biss Key”... - Page 17 cancel the scan. The channels that have already been Press OK to store the new frequency for that channel. found will be stored in the channel list. Press Back to cancel. This item may not be visible, depending on whether or not the last watched channel Update Scan: Search for updates.
- Page 18 tem, Sound System, Modulation and Symbol Rate Channel Move: Move a channel to the position of information related to that channel. Depending on the another channel. Highlight the channel you want to channel other options may also be editable. You can move and press OK to select.
-
Page 19: Accounts & Sign In
Special app access: Configure some app features Audio Channel and special permissions. Set the audio channel preference, if available. This Security & restrictions: Using the options of this item may not be visible, depending on whether or not menu; the last watched channel was analogue. •... - Page 20 Power Display Mode: Set the aspect ratio of the screen. Select one of the predefined options according to Sleep Timer: Define an idle time after which you your preference. want your TV to enter sleep mode automatically. HDR: Turn the HDR function on or off. This item will Picture off: Select this option and press OK to be available if HDR content is detected.
- Page 21 manually. Highlight Enable and press OK to turn Sound Mode: If the Dolby Audio Processing this function on. option is turned on Sound Mode option will be available to set. Highlight the Sound Mode option 11 Point White Balance Correction: White bal- and press OK to see the preset sound modes.
-
Page 22: Bluetooth Remotes & Accessories
Headphone: Turn this option on if you want to be available depending on the selected country during route the sound of the audio commentary to the the initial setup process. TV’s headphone output. To filter the channels highlight Select Type and press Volume: Adjust the volume level of the audio the OK button. -
Page 23: Programme Guide
The status of the connection under the Ethernet Programme Guide section in the Network & Internet menu will changed from Not connected to Connected. By means of Electronic Programme Guide (EPG) function of your TV you can browse the event schedule of the currently installed channels on your channel list. -
Page 24: Multi Media Player
A stable connection speed is required to play back streaming content. Use an Ethernet connection if the wireless LAN speed is unstable. Multi Media Player On the Home Screen scroll to Apps row, select Multi Media Player (MMP) and press the OK button to launch. -
Page 25: From A Mobile Device Via Dmr
Make sure that your mobile device is connected to the authors' rights. Toshiba asks you to respect the same network as your TV. On the TV, scroll to Apps intellectual property rights of third parties. -
Page 26: Schedule List
dialogue will be displayed. Highlight Yes and press To operate the connected CEC device, select the OK to start formatting. related HDMI input source from the Inputs menu on the Home Screen. Or press the Source button if the TV IMPORTANT: Formatting your USB storage device is in Live TV mode and select the related HDMI input will erase ALL the data on it and it’s file system will be... -
Page 27: Hbbtv System
articles. You can also change the name of your TV. cation on that channel. Press the button indicated on Highlight Device name and press OK. Then highlight the screen to launch the application. Change and press OK again. You can either select HbbTV applications use the buttons on the remote one of the predefined names or enter a custom name. -
Page 28: Troubleshooting & Tips
No sound / poor sound Troubleshooting & Tips • Make sure that the sound settings are correctly set. • Make sure that all cables are properly connected. TV does not switch on • Make sure that the volume is not muted or set to •... -
Page 29: Vga Input Typical Display Modes
VGA Input Typical AV and HDMI Signal Display Modes Compatibility The following table is an illustration of some of the Source Supported Signals typical video display modes. Your TV may not support all resolutions. SECAM Composite Index Resolution Frequency / Back AV NTSC4.43 NTSC3.58 640x480... -
Page 30: Supported File Formats For Usb Mode
Supported File Formats for USB Mode Video Video Codec Resolution Bit Rate Profile Container MKV (.mkv) 1920x1080@60fps 40Mbps Profile0,2 WebM (.webm) MP4 (.mp4, .mov), 3GPP (.3gpp, .3gp), Main/Main10 MPEG transport stream (.ts, .trp, .tp), HEVC/H.265 1920x1080@60fps 50Mbps Profile, High Tier MKV (.mkv), WebM (.webm), FLV (.flv), @Level 4.1 AVI (.avi), H265 (.265) -
Page 31: Audio
Video Codec Resolution Bit Rate Profile Container AVI (.avi), 3GPP (.3gpp, .3gp), MP4 Motion JPEG 640x480@30fps 10Mbps (.mp4, .mov), MKV (.mkv), WebM (.webm), FLV (.flv), OGM (.ogm) MKV (.mkv), WebM (.webm), FLV (.flv), 1920x1080@60fps 20Mbps 3GPP (.3gpp, .3gp), MP4 (.mp4, .mov), AVI (.avi), OGM (.ogm) RM (.rm, .rmvb), MKV (.mkv), WebM RV30/RV40... - Page 32 Audio Codec Sample rate Channel Bit Rate Container Note AAC-LC: AAC (.aac), AVI (.avi), MKV (.mkv, .mka), WebM (.webm), 3GPP 12kbps~ (.3gpp, .3gp), MP4 (.mp4, .mov, 576kbps m4a), MPEG transport stream (.ts, AAC-LC, HEAAC 8KHz ~ 48KHz Up to 5.1 V1 6kbps ~ .trp, .tp), MPEG program stream (.DAT, .VOB, .MPG, .MPEG), FLV...
-
Page 33: Picture
Audio Codec Sample rate Channel Bit Rate Container Note 8KHz 6Kbps ~ 11.025KHz, LBR (cook) Up to 5.1 RM (.rm, .rmvb, .ra) 128Kbps 22.05KHz, 44.1KHz MKV (.mkv, .mka), WebM (.webm), FLAC 8KHz~96KHz Up to 7.1 < 1.6Mbps FLAC (.flac) 6Kbps ~ MKV (.mkv, .mka) OPUS 8KHz ~ 48KHz... -
Page 34: Supported Dvi Resolutions
External File Extension Subtitle Parser Remark .srt SubRip SubStation Alpha .ssa/ .ass Advanced SubStation Alpha .smi SAMI MicroDVD .sub SubIdx (VobSub) .txt TMPlayer Supported DVI Resolutions When connecting devices to your TV’s connectors by using DVI converter cable(DVI to HDMI cable - not supplied), you can refer to the following resolution information. -
Page 35: Disposal Information
Disposal Information The following information is only for EU-member states: Disposal of products The crossed out wheeIed dust bin symbol indicates that products must be collected and disposed of separately from household waste. Integrated batteries and accumulators can be disposed of with the product. They will be separated at the recycling centres.