Vcr Setup - Sony CS SLV-998HF MX Operating Instructions Manual
Sony video cassette recorder operating instructions slv-998hf, slv-998hf, cs slv-998hf mx, slv-998hf
Hide thumbs
Also See for CS SLV-998HF MX:
- Operating instructions manual (100 pages) ,
- Service manual (82 pages) ,
- Dimensions (1 page)
Table of Contents
Advertisement
Step 3: Hookups (continued)
C
Use this hookup if your TV has the S-Link™ function
Note
*
To play a tape in stereo, you must use the A / V connection.
A / V hookup:
VCR setup
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select
ADVANCED OPTIONS.
MENU
TIMER SET / CHECK
TUNER PRESET
CLOCK SET
LANGUAGE
SET VCR Plus+ CHANNELS
CABLE BOX CONTROLS
ADVANCED OPTIONS
Use
to
item,
then
push
Caution
Connections between the VCR's VHF / UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
10
Getting started
VCR
Audio/video cable (supplied)
select
an
OK
TV
Audio cable (not supplied)
Set Auto ANT SEL to
OFF and press OK.
ADVANCED OPTIONS
AUTO ANT SEL
AUTO STEREO
AUDIO MIX
TUNER AUDIO
SHARPNESS
Use
to
select
item,
then
push
Stereo receiver
page 1
ON
OFF
ON
OFF
ON
OFF
MAIN
SAP
L
H
an
Advertisement
Table of Contents
