Toshiba TECRA A8 series Maintenance Manual page 250
Personal computer
Hide thumbs
Also See for TECRA A8 series:
- Maintenance manual (428 pages) ,
- User manual (306 pages) ,
- Resource manual (56 pages)
Table of Contents
Advertisement
4 Replacement Procedures
Disassembly Procedures
The computer has two basic types of cable connectors:
• Pressure Plate Connectors
• Coaxial Cable Connectors
• Normal Pin Connectors
To disconnect a Pressure Plate connector, lift up the tabs on either side of the connector's
plastic pressure plate and slide the cable out of the connector. To connect the cable to a
Pressure Plate connector, make sure the pressure plate is fully lifted and slide the cable into
the connector. Secure the cable in place by pushing the sides of the pressure plate down so
the plate is flush with the sides of the connector. Gently pull on the cable to make sure the
cable is secure. If you pull out the connector, connect it again making sure the connector's
pressure plate is fully lifted when you insert the cable.
Coaxial cables should be disconnected with an antenna coaxial disconnector.
Normal Pin connectors are used with all other cables. These connectors can be connected
and disconnected by simply pulling them apart or pushing them together.
Assembly Procedures
After you have disassembled the computer and fixed or repaired the problem that was
causing the computer to operate abnormally, you will need to reassemble the computer.
Install all the removed FRUs following the steps described in the corresponding sections in
this chapter.
While assembling the computer, remember the following general points:
• Take your time, making sure you follow the instructions closely. Most problems
• Make sure all cables and connectors are securely fastened.
• Before securing the FRU or other parts, make sure that screws or the FRU will
• Check that all latches are closed securely in place.
• Make sure all the correct screws are used to secure all FRUs. Using the wrong
After installing an FRU in the computer, confirm that the FRU and the computer are
functioning properly.
4-4
Downloaded from
www.Manualslib.com
arise when you get in a hurry assembling the computer.
pinch no cables.
screw can either damage the threads on the screw or the head of the screw and
may prevent proper seating of an FRU.
[CONFIDENTIAL]
manuals search engine
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
4.1 General
- Quick Links:
- Figure 1-1 Front of the Computer
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
