Toshiba TECRA A8 series Maintenance Manual page 264
Personal computer
Hide thumbs
Also See for TECRA A8 series:
- Maintenance manual (428 pages) ,
- User manual (306 pages) ,
- Resource manual (56 pages)
Table of Contents
Advertisement
4 Replacement Procedures
Installing the MDC/Memory module
To install the MDC/memory module, follow the steps below and refer to Figure 4-8 and 4-9.
CAUTION: When installing the memory module, make sure the computer is in boot
1. Insert the memory module into the connector slantwise and press it to connect firmly.
2. Press down the memory module until it is latched firmly.
NOTE: When the power of the computer is turned on, the computer checks automatically
3. Connect the MDC cable to the connector on the MDC.
4. Peel up the insulator and connect the MDC to the connector CN3010 on the system
board by pressing it carefully. Be careful not to damage the MDC and connector.
5. Secure the MDC with the following screws.
6. Install the MDC/memory cover and secure it with the screw (with a washer).
4-18
Downloaded from
www.Manualslib.com
mode and powered off. Inserting a memory module with the power on might
damage the module or the computer itself.
When installing only one memory module, be sure to insert it into the slot A.
Otherwise, the computer or the memory may not work properly.
Do not touch the connectors on the memory module or on the computer.
Dust and stains on the connectors may cause memory access problems.
the memory size. Confirm that the new memory is detected correctly.
If the memory is not detected, check that it is connected correctly.
•
M2×4B
BIND screw
[CONFIDENTIAL]
manuals search engine
×2
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
4.6 MDC/Memory module
- Quick Links:
- Figure 1-1 Front of the Computer
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
