Installation Instructions DA398-6, DA399-6 en - CA Installation, repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions.
Installation Before installation Disassembly If the device ever needs to be Before installing the appliance, disassembled, follow the installation read all of the information contained sheet instructions in reverse order. A in this chapter and also in the lever is provided to assist with the "IMPORTANT SAFETY removal of the chimney.
Page 4
Installation a 3 protective installation sheets for use when installing the chimney b 1 exhaust connector 8 screws, ³/₁₆" x 2 ³/₈" (5 x 60 mm) for an exhaust duct 6" (150 mm). 8 plugs, ⁵/₁₆" x 2" (8 x 50 mm) c 1 reducer for attaching to the wall (not for use in for an exhaust duct ...
Please also observe the information contained in the "IMPORTANT SAFETY INSTRUCTIONS" section. Minimum distance S Cooking appliance Miele Non-Miele appliance appliance Electric/Induction cooktop 24" (610 mm) Electric grill, deep fat fryer (electric) 26"...
Installation Installation recommendations Drilling diagram for wall mounting – We also recommend a distance of at least 25 ¹/₂" (650 mm) above electric When drilling, please follow the cooktops to provide more workspace directions contained on the and easier cooking under the hood. accompanying installation sheet.
Installation Plywood backing Make a cutting line 3" (76 mm) above and 3" (76 mm) below the outline of The majority of the weight of the the retaining plate. installed ventilation system will be Find the studs to the left and right supported by the lower retaining of the mounting location by tapping plate.
Exhaust duct – Make sure that all connections are WARNING: Danger of toxic fumes. secure and airtight. Gas cooking appliances release carbon monoxide that can be Remember that any constriction of harmful or fatal if inhaled. the airflow will reduce extraction To reduce the risk of fire and to performance and increase operating properly exhaust air, the exhaust...
Exhaust duct Condensate trap Reducing Collar (optional accessory) If you would like to reduce the In addition to insulating the exhaust environmental impact of your ventilation duct, we recommend installing a system by limiting the CFM output the condensate trap to collect and Reducing Collar can be installed.
Service and warranty For faults that you cannot resolve on your own, please contact your Miele dealer or Miele Technical Service. The telephone number for the Technical Service Department is listed at the back of these instructions. When contacting Miele, please state the model and serial number of your ventilation hood.
Technical data Fan motor 350 W Cooktop lighting 2 x 50 W Total connected load 450 W Voltage, Frequency 120 V AC, 60 Hz Fuse rating 15 A Power cord length 2.5 ft (0.75 m) Weight DA 398-6 55.3 lbs (25.1 kg) DA 399-6 57.2 lbs (26 kg) Optional accessories for recirculation mode:...
Page 14
Technical Service. U.S.A. Canada Miele, Inc. Importer Miele Limited National Headquarters 9 Independence Way Headquarters and Miele Centre Princeton, NJ 08540 161 Four Valley Drive Phone: 800-843-7231 Vaughan, ON L4K 4V8 609-419-9898 www.miele.ca 609-419-4298...
Page 15
DA 398-6 DA 399-6 en-US M.-Nr. 09 968 240 / 02...