Replacement Procedures
4.9
Optical disk drive
NOTE: Do not apply excessive force to the top of an optical disk drive.
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
Removing an optical disk drive
The following describes the procedure for removing an optical disk drive (See Figure 4-13
and 4-14).
1. Turn over the computer and remove the following screws securing an optical disk
drive.
•
2. Upside down the computer.
3. Remove the following screw securing the ODD driver.
M2.5×6.0B
3. Disconnect an optical disk drive toward the arrow direction from the connector
CN25 on the system board.
Satellite L20 Maintenance Manual(960-Q01)
M2.5×6.0B
FLAT BIND screw
Flat BIND screw
x1
x1
171