Table of Contents
Advertisement
HCD-DX375
DVD SECTION
When the base unit is replaced, perform the adjustment and the
measurement as shown below in this order.
1) MIRROR TIME ADJUSTMENT (See page 29)
2) EXECUTING IOP MEASUREMENT (See page 31)
[TEST DISC LIST]
Be sure to use the DVD disc that matches the signal standards of
your region.
• CD
YEDS-18 (Part No.: 3-702-101-01)
PATD-012 (Part No.: 4-225-203-01)
• DVD SL (Single Layer)
NTSC : HLX-503
(Part No.: J-6090-069-A)
HLX-504
(Part No.: J-6090-088-A)
PAL : HLX-506
(Part No.: J-6090-077-A)
• DVD DL (Dual Layer)
NTSC : HLX-501
(Part No.: J-6090-071-A)
HLX-505
(Part No.: J-6090-089-A)
PAL : HLX-507
(Part No.: J-6090-078-A)
[RF Level Check]
Connection:
DMB12 board
CN105 pin 6 (RFMON)
CN105 pin 3 (GND)
Procedure:
1. Connect an oscilloscope to CN105 pin 6 (RFMON) and
CN105 pin 3 (GND) on the DMB12 board.
2. Turn the power on.
3. Insert the CD test disc (refer to the TEST DISC LIST), and
press the H button to play the disc back.
4. Confirm that oscilloscope waveform is clear and check RF
signal level is correct or not.
Note: A clear RF signal waveform means that the shape "◊" can be
clearly distinguished at the center of the waveform.
5. Eject the CD disc, and insert the DVD SL test disk (refer to
the TEST DISC LIST), and press the H button to play the
disc back.
RF signal waveform
32
SECTION 5
ELECTRICAL ADJUSTMENT
(DVD ONLY)
oscilloscope
+
–
VOLT/DIV: 200 mV
TIME/DIV: 500 ns
level: 0.57 to 1.1 Vp-p (CD)
0.58 to 1.23 Vp-p (DVD)
Checking Location: DMB12 board (Side A)
DMB12 BOARD
(SIDE A)
HDMI OUT
CN105 Pin 3 (GND)
CN105 Pin 6 (RFMON)
IC101
IC201
1
CN105
3
6
OPTICAL PICK-UP
SPINDLE MOTOR
BLOCK
SLED MOTOR
(KHM-310CAB)
Hide quick links:
Advertisement
Table of Contents
