Table of Contents
Advertisement
en Rinse aid system
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
Press the catch on the lid of the
1.
dispenser for rinse aid
.
Add rinse aid up to the max mark.
2.
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
Close the lid of the dispenser for
4.
rinse aid.
a The lid clicks into position.
26
and lift
2
1
max
11.2 Setting the amount of
rinse aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
Press
.
1.
Press and hold
2.
Turn the programme selector until
3.
the display shows r:05.
Release the button.
4.
Turn the programme selector until
5.
the right amount of rinse aid has
been set.
The factory setting is level r:05.
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
Press
to save the setting.
6.
11.3 Switching rinse aid sys-
tem off
If you find the rinse aid refill indicator
irritating, e.g. when using combined
detergents with a rinse aid compon-
ent, you can switch the rinse aid sys-
tem off.
Tip: The function of rinse aid is lim-
ited with combined detergents. You
will generally get better results using
rinse aid.
Press
.
1.
Press and hold
2.
Turn the programme selector until
3.
the display shows r:05.
Release the button.
4.
Turn the programme selector until
5.
the display shows r:00.
.
.
Advertisement
Table of Contents
