4: Connecting The Ac Power Cord - Sony HT-DDW670 Operating Instructions Manual
Hide thumbs
Also See for HT-DDW670:
- Operating instructions manual (84 pages) ,
- Specifications (2 pages) ,
- Speakers connection (2 pages)
Table of Contents
Advertisement
Setting the voltage selector
If your receiver has a voltage selector on the rear
panel, check that the voltage selector is set to the
local power supply voltage.
If not, use a
screwdriver
to set the selector to the correct
position belore connecting the AC power cord to
a wall outlet.
Connecting
the AC power
cord
Connecl the AC power cord to a wall oullet.
To a wall
outlet
Performing
initial
setup
operations
Before using Ihe receiver
h)r the lirst lime,
inilialize the receiver by performing
the
fl)llowing procedure.
This procedure
can also be used lo return
settings you have made Io their faclory defaults.
Use the bullOllS on Ihe receiver
for lhe operation.
1
Press I/@ to turn off the receiver.
2
Hold down I/_
for 5 seconds,
"PUSH"
and "ENTER"
appears in the
display allernalingly.
3
Press ENTER.
"CLEARING"
appears in tile display for a
while, then "CLEARED"
appears.
The following
are reset 1(! Iheir factory
sellings.
• All seltings
in the SET UP, LEVEL,
TONE and CUSTOMIZE
menus.
• The sound field memorized
for each
inpul and preset stalion.
• All sound field paramelers.
• All presel slatious.
• All index names for inputs and presel
stations.
• MASTER
VOLUME
1+ is set to'WOE
MIN'.
AC power cord
14GB
Advertisement
Table of Contents
