Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
Mounting
5
Filter
Flat head
7
wood screw
Remote controller
4
holder
Wireless
2
remote controller
Optional Installation Parts
Part
Parts name
code
Refrigerant piping
Liquid side : Ø6.35 mm
A
Gas side
: Ø9.52 mm
Pipe insulating material
B
(polyethylene foam, 6 mm thick)
Putty, PVC tapes
C
Hook
6
screw
Hook
Apply after carrying
out a drainage test.
3
Batteries
Q'ty
One
each
1
One
each
Hook
Installation
1
plate
Shield pipe
Vinyl tape
Saddle
Extension drain hose
(Not available, provided
by installer)
Fixing bolt arrangement of outdoor unit
• Secure the outdoor unit with fixing bolts and nuts if the unit is likely to be
exposed to a strong wind.
• Use Ø8 mm or Ø10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple " and cap
water proof # to the bottom plate of the outdoor unit before installing it.
197 mm
29 mm
108 mm
Air outlet
600 mm
6
For the rear left and bottom left piping
Wall
Cut out a piece of SPACER from indoor
unit packaging box, roll it and insert
between the indoor unit and wall to tilt
the indoor unit for better operation.
The auxiliary piping can be connected
to rear left, rear right, bottom right or
bottom left.
Rear right
Bottom
Rear
right
left
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
Refrigerant piping must be protected
from physical damage.
Install a plastic cover or equivalent.
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
125 mm
Air outlet
* Drain nipple and
99 mm
Drain outlet
Bottom left
cap water proof are
packed in outdoor
unit.
Advertisement
Table of Contents
