Table of Contents
Advertisement
en Water softening system
Water hardness °E
39 - 62
Note: Set the water hardness determ-
ined on your appliance.
→ "Setting the water softening sys-
tem", Page 24
With a water hardness of 0 - 8 °E
you can dispense with special salt for
dishwashers and switch off the water
softening system.
→ "Switching off the water softening
system", Page 25
Setting the water softening
system
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 23
Press
.
2.
To open the basic settings, press
3.
for 3 seconds.
a The display shows Hxx.
a The display shows
Press
repeatedly until the
4.
right water hardness has been set.
The value H04 is set at the factory.
To save the settings, press
5.
for 3 seconds.
Special salt
You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The amount of spe-
cial salt required depends on the wa-
24
Hardness range
Hard
.
mmol/l
5.5 - 8.9
ter hardness: the higher the water
hardness, the greater the amount of
special salt required.
ATTENTION!
¡ Detergent may damage the water
softening system.
Only fill the dispenser of the wa-
▶
ter softening system with special
dishwasher salt.
¡ Special salt for dishwashers can
damage the tub due to corrosion.
To make sure that any special
▶
salt that escapes is washed out
of the tub, add the special salt
to the dispenser for special salt
immediately before the pro-
gramme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Setting value
H07
Advertisement
Table of Contents
