Table of Contents
Advertisement
8. APPLIED CONTROL
8-1. Method to set indoor unit function DN code
(When performing this task, be sure to use a wired remote controller.)
Procedure
Be sure to stop the air conditioner before making settings
<RBC-AMT
>
1
Push the
+
+
least 4 seconds.
The unit No. displayed first is the address of the header indoor unit in group
control.
Then the fan and louver of the selected indoor unit move.
UNIT LOUVER
2
Each time the
one of the indoor unit Nos. under group control is displayed in
turn. Then the fan and louver of the selected indoor unit move.
3
TEMP.
Use the
button to select the CODE No. (DN code) of the
desired function.
4
Use the
button to select the desired SET DATA
associated with the selected function.
5
Push the
button. (The display changes from flashing to
steady.)
• To change the selected indoor unit, go back to step
• To change the selected function, go back to step
6
When the
button is pushed, the system returns to normal
off state.
<RBC-ASCU11- >
1
Push and hold menu button and [
• After a while, the display flashes as shown in the figure. "ALL" is displayed as indoor unit numbers during
initial communication immediately after the power has been turned on.
2
Each time [
] [
change cyclically. Select the indoor unit to change settings for.
• The fan of the selected indoor unit runs . The indoor unit can be confirmed for which to change settings.
buttons simultaneously and hold for at
button (left side of the button) is pressed,
3
.
3,6
4,5
1
] setting button simultaneously for 10 seconds or more.
Indoor unit No.
] setting button is pushed, indoor unit numbers in the group control
2
.
2,4,5
7
- 33 -
10
CODE No.
SET DATA
00 01
TEST
SETTING
UNIT No.
1-1
R.C.
No.
TEMP.
ON / OFF
TIMER SET
FAN
MODE
TIME
SAVE
VENT
FILTER
RESET
TEST
SET
CL
SWING/FIX
UNIT LOUVER
5
4
3
1
2
6
Advertisement
Chapters
Table of Contents
Troubleshooting
