Sony RDR-GX310 Operating Instructions Manual page 54
Dvd players & recorders: dvd recorder
Hide thumbs
Also See for RDR-GX310:
- Operating instructions manual (112 pages) ,
- Service manual (123 pages)
Table of Contents
Advertisement
Buttons
(slow, freeze frame)
- RW
+
RW
VR
+
R
-
R
*
VCD
* Playback direction only
X PAUSE
To resume normal playback, press H PLAY.
b
Notes
• To enjoy the TVS function, set "Digital Out" to "On"
and "Dolby Digital" to "D-PCM" in "Audio" setup.
• The volume may be reduced when surround effects are
set.
• When the playback signal does not contain a signal for
the rear speakers, the surround effects will be difficult
to hear.
In addition, the surround effects may also be difficult to
hear depending on the title being played and the
environment where the recorder is being used.
• When you select one of the surround modes, turn off
the surround settings of the connected TV or amplifier
(receiver).
• Make sure that your listening position is between and
at an equal distance from your speakers, and that the
speakers are located in similar surroundings.
• Angles and subtitles cannot be changed with titles
recorded on this recorder.
• 96 kHz PCM audio and DTS audio do not have
surround effects.
54
Operations
Plays in slow motion when pressed for more than one second in pause mode.
Plays one frame at a time when pressed briefly in pause mode.
+
RW
DVD
Pauses playback.
Notes on playing DTS sound tracks on a CD
• When playing DTS-encoded CDs, excessive noise will
be heard from the analog stereo jacks. To avoid
possible damage to the audio system, the consumer
should take proper precautions when the analog stereo
jacks of the recorder are connected to an amplification
system. To enjoy DTS Digital Surround™ playback, an
external 5.1-channel decoder system must be
connected to the digital jack of the recorder.
• Set the sound to "Stereo" using the AUDIO button
when you play DTS sound tracks on a CD (page 53).
Notes on playing DVDs with a DTS sound track
DTS audio signals are output only through the DIGITAL
OUT (COAXIAL or OPTICAL) jack.
When you play a DVD with DTS sound tracks, set
"DTS" to "On" in "Audio" setup (page 79).
Advertisement
Table of Contents
