How To Connect The Extension Cable - Sony MVC-FD71 Service Manual
Hide thumbs
Also See for MVC-FD71:
- Operating instructions manual (80 pages) ,
- Operating instructions manual (80 pages) ,
- Limited warranty (1 page)
Table of Contents
Advertisement
[How to connect the extension cable]
1) Remove the PK-43 board and the liquid crystal indication
module. (See page 2-2E.)
Note : Be careful not to breake the flexible board of the floppy disk drive.
2) Install the Extension cable (J-6082-427-A) on the rear cabi-
net. (See Fig. 1.)
Four screws
Fig. 1
3) Install the floppy disk drive. (See Fig. 2.)
Floppy disk drive
Fig. 2
Extension cable
(J-6082-427-A)
Extension cable
(J-6082-427-A)
Flexible board
(CN012)
Flexible board
(CN011)
4) Open the lithium lid. (See Fig. 3.)
5) Mount the flexible board on CN013. (See Fig. 3.)
Contact side
CN013
Contact side
Extension cable
(J-6082-427-A)
6) Install the PK-43 board. (See Fig. 4.)
Contact side
CN602
For both two cables,
the contact points are
on this side.
Note : The floppy disk drive and PK-43 board could be destroyed unless
the flexible board is connected normally to the connector.
(See Fig. 5.)
Good
– 5 –
Lithium lid
Fig. 3
PK-43 board
Contact side
CN601
Extension cable
(J-6082-427-A)
Fig. 4
NG
Fig. 5
Hide quick links:
Advertisement
Table of Contents
